LMS 1A Series User Manual

Note that the stylus may not move freely if the recorder is in the imprint section of its
operating cycle with the stylus pressed against the chart paper. In this case the recorder
chart motor should be operated for a few seconds until the imprint pressure is released, or
the imprint drive wheel (12) can be manually rotated. The chart paper can be manually
advanced by operating the manual paper feeding wheel (7) to set the desired zero time
osition. p
24 of 31
01/12

LMS 1A Series Specifications

General

Brand	LMS
Model	1A Series
Category	Accessories
Language	English