LNS ALPHA SL65 S - Service Parameters Quick Preview

SERVICE PARAMETERS
SERVICE MANUAL – ALPHA SL 65S
QUICK PREVIEW
Parameter page
Parameter name
Description
Access
MODE 1 Simulation
The bar feeder will run feeding and bar
change cycles
automatically without
controlled by interface signals or manual
operation
F1
MODE 2 A1-Chuck Invert
Define chuck action when receiving
CHUCK signal
MODE 3 A2-Auto Invert
Define lathe is in auto mode when receiving
A2 signal
MODE 4 A3-Loading Invert
Define loading cycle action when receiving
START LOADING signal
MODE 5 A4-Feed Invert
Define moving bar forward action when
receiving PUSH signal
MODE 7 Loading new bar
Define the approach whether according to
A3 signal or not for initiating bar loading
MODE 9 Feeding Safety
Check for bar feeder when the lathe has
been already in AUTO mode
MODE 10
Y05 Start Signal
Define when will output the START signal
MODE 11
Y06 EOB Signal
Output Type
Define when will output the End of Bar
signal
MODE 12
Application Setup
Eject with pusher
Define when the remnant will be ejected by
pusher
MODE 13 Speed Choice
Define turning speed of servo motor during
bar loading
MODE 15
Language setup
Language setup
MODE 16 Spindle Inching
Define whether the pusher moves back and
forth or not
MODE 18 Part Length Check
Define when to start safety check for
feeding
MODE 19 Unit of Measure
Define the unit for measuring length in
parameters
MODE 20
Interface Test
Define whether interface test is applied
MODE 21 P01 Upper Limit
Define whether maximum movement for
pusher moving activate or not
MODE 22 Forward Limit
Define how the moving forward limit for the
pusher
MODE 23 Barstock Verification
Define whether the pusher moves forward
to check bar stock or not
MODE 24 A4 Signal
Define A4 signal belongs to the pulse signal
or continuous ON signals
MODE 25 A7-Door Invert
Define lathe door action when receiving
lathe door signal