To Next PageTo Next Page
Need help?Do you have a question about the Lock Control ST-780 Series and is the answer not in the manual?
General| Brand | Lock Control |
|---|---|
| Model | ST-780 Series |
| Category | IP Access Controllers |
| Language | English |
Power supply specs, wire gauge, and separation for reliable operation.
Guidance on ideal installation locations and waterproofing.
Available communication interfaces and card type examples.
Details on electric lock types and surge protection for longevity.
Waterproof design and LED indicators for operational status.
Features for computer connectivity, data storage, and user management.
Internal battery backup, access control parameters, and security sensing features.
Details on external connectivity, frequency, range, dimensions, and power.
Steps for mounting, connecting power, and verifying initial power status.
Procedures for entering setting mode, password entry, and connecting to computer.
Steps for adding/deleting cards and exiting setting mode in standalone operation.
Explanation of LED indicators and the function of the # and * keys.
Lists the different ST-780 reader models and their associated frequencies.
Details on SC-10, SC-20, SC-30, SC-50 cards, including dimensions and read ranges.
How the reader starts up and the meaning of proximity sensing feedback.
Activating the anti-duress function and accessing the system setup mode.
Procedures for adding and deleting user cards efficiently.
Steps to set the current time and date on the reader.
Configuring door open time, reader number, and door open modes.
Step-by-step guide for registering new proximity cards or card numbers.
Instructions for removing registered cards from the system.
Setting the duration the door remains open after activation.
Choosing between card-only or card-and-password door opening methods.
Procedure to update the system's administrative password.
Assigning unique identification numbers to readers for system management.
Shows the current number of cards registered in the system.
Step-by-step guide to accurately set the reader's current time.
Step-by-step guide to accurately set the reader's current date and day.
Configuration for indoor or outdoor installation location of the reader.
Setting to enable or disable the display of card numbers.
Procedure for emergency door opening via setup mode.
Configuration of serial communication parameters (N.8.1 or N.8.2).
Setting the Wiegand output format to 26-bit or 34-bit.
Enabling door access using a registered card's 8-digit number.
Configuring access to allow all cards or only registered cards.
Details the pin assignments for the 5-pin and 8-pin reader connectors.
Guides for connecting electric locks (N.O./N.C.) and push buttons.
Instructions for wiring fail-safe electric locks using N.O. and N.C. connectors.
How to connect a reed switch for monitoring the door's open/closed state.
Connecting a device to the anti-duress alarm output terminal.
Connecting a device to the general alarm output terminal.
Instructions for connecting the reader to a PC for data management.
How to wire an additional door bell using an external relay.
Instructions for connecting an external sub-reader to the main unit.
Example wiring for door open point with external relay and related precautions.
Steps for disassembling, applying sealant, and mounting the unit's base.
Routing wires, connecting to the unit, and securing the reader.
Key considerations before and during installation for safety and performance.
Solutions for when the reader does not respond or the door fails to open.
Solutions for problems entering system functions after password entry.
