What to do if the LockUP Keypad makes 10 rapid beeps?
If your LockUP Keypad emits 10 rapid beeps during operation, try the following: * Press firmly on the door while operating the keypad. * Loosen the screws or locking nuts. * Remove the lock from the door, assemble it in your hand away from the door, and test its operation. If it works, reinstall it on the door.
What to do if there is no audible feedback when the '=' button is pressed on my LockUP Employee Lock?
If there is no audible feedback when you press the '=' button on your LockUP Keypad, it could be due to several reasons: * **Poor Pin Connection:** Remove the lock from the door and reinstall it. If the issue continues, remove the lock and assemble it in your hand to test. * **Dead Batteries:** Touch a registered Manager Flex Key to the key slot for 30 seconds, remove it, and immediately retouch it to unlock the lock. If it works, replace the batteries. * **Over-Tightened:** Loosen the mounting screws and then press the '=' button. * **Sleep State:** Wait one minute and try again, or touch a registered Manager Flex Key for immediate access.
Covers product defects in material and workmanship within two years of purchase.
Step-by-step process for initializing new locks.
Procedure for replacing lost or stolen Manager Flex Keys.
How to lock and unlock using a user code.
How to lock and unlock using an ADA User Key.
How to lock and unlock using a Manager Flex Key.
Detailed steps for locking/unlocking with a user code.
Detailed steps for locking/unlocking with an ADA User Key.
Detailed steps for locking/unlocking with a Manager Flex Key.
Explains common audible and visual feedback from the lock.
Details specific warning indicators and their meanings.
Instructions for replacing the lock's batteries.
Addresses lack of audible feedback when a button is pressed.
Solutions for when the lock fails to unlock with code or key.
Interprets the lock's audible and visual indicators.
Explains common lock feedback signals.
To Next Page
General