Description2
5 Button
Button for switching the measuring units for the dispensing pressure in the digital display.
After each pressing of button the indication of the selected dispensing pressure in the digital
display changes to the other measuring unit [bar] or [psi] with the corresponding value.
6 Button
Button for switching from time controlled mode to continuous mode.
The lighting of the LED in button indicates continuous mode (see Section 5.2.2.2).
By pressing button the indication of the dispensing time in the digital display is set to 0.00 s and
blinks. During dispensing, the elapsed dispensing time is indicated in the digital display beginning
each time with 0.00 s. The last dispensing time remains displayed until the next start.
– Switching back to time controlled mode without storage of the dispensing time by renewed
pressing of button . The LED in button extinguishes. In the digital display, the dispensing time
previously stored for the time controlled mode reappears.
– Switching back to time controlled mode with storage of the dispensing time by pressing
button . The LED in button extinguishes. The indicated dispensing time is stored and the
display stops blinking.
7 Power Switch I/O (ON/OFF)
The control unit is switched on and off with the power switch.
When a product reservoir is connected, the following also applies:
Position I (ON) – The reservoir is automatically pressurized with the dispensing pressure set
on the precision pressure regulator.
Position O (OFF) – The reservoir is automatically depressurized.
8 Precision Pressure Regulator
Precision regulator for adjusting the dispensing pressure.
By turning the regulator knob, the dispensing pressure is adjusted in the range from 0.00 to 7.00 bar
(0.00 to 100 psi).
If the error message „ Press. 0.83 NOK “ appears with beeping, the dispensing pressure was
changed more than ± 10 %. The value 0.83 [bar/psi] is only an example for the displayed dispensing
pressure (see Chapter 7).
By pressing button the indicated dispensing pressure is stored as the new comparison value for
automatic pressure monitoring. The error message and beeping is eliminated.
9 Exhaust Air Silencer
To Next Page
Loading...
