Loctite Single CureJet - 1. PLEASE OBSERVE THE FOLLOWING; 1.2 Items Supplied; 1.3 For Your Safety

1. Please Observe the Following
1.1 Emphasized Sections
WARNING!
Refers to safety regulations and required measures that protect the operator or other persons from
injury or danger to life.
Caution!
Emphasizes what must be done or avoided so that the unit or other property is not damaged.
Notice:
Gives recommendations for better handling of the unit during operation or adjustment, as well as
for service activities.
1.2 Items Supplied
1 Loctite
®
CureJet
TM
Controller
1 AC Power Cord
1 Orange Safety Glasses
1 Foot Switch
1 Operation Manual
1 Side Mounting Kit
1.3 For Your Safety
For safe and successful operation of the unit, read these instructions completely. If the
instructions are not observed, the manufacturer can assume no responsibility. Be sure to retain
this manual for future reference.
WARNING!
While the Loctite
®
CureJet
TM
LED Light Sources have minimal output in the UV-A range, the
use of UV safety glasses that conform to ANSI Z87.1/CSA Z94.3 (Such as Loctite
®
P/N 98452)
is recommended when operating the unit.
WARNING!
Never directly expose skin to light source.
WARNING!
Never look into the end of the light source.
WARNING!
Damage to the AC power cord can result in contact with live electrical parts. Check the power
cord before each use. If the power cord is damaged, do not operate.
WARNING!
1364033 Single CureJet
TM
Controller will operate all existing CureJet
TM
Light Sources and
all new CureJet
TM
Light Sources. LED Controller 976419 will only operate 976420 (405) LED
Light Sources, and
976418 (Indigo
TM
) LED Light Sources.
The unit may be repaired only by a Henkel authorized service technician.