Loctite Single CureJet - 5. CARE AND MAINTENANCE

1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
CURE
LIGHT
ON
OVERHEAT
START
SIGNAL
LED CONTROLLER EXTERNAL CONTROLLER
Figure 3. XS 1 Wiring Diagram
5. Care and Maintenance
Notice:
It is recommended that the light output from the light source be monitored regularly using a
Loctite
®
Visible Light LED Dosimeter, P/N 1265282 and UV-B&A LED Qualified
Radiometer P/N 1390323.
Caution!
It is recommended that the end of the light source be positioned no closer than 0.25” inch from
the Loctite
®
product being cured to minimize adhesive contamination on the light source tip. If
adhesive should contaminate the light source tip, be sure to clean the light source tip to
maximize the unit’s effective output.
Notice:
Vapors from some products may gradually accumulate on the end of the light source, reducing
the light output. It should be inspected regularly and cleaned as necessary using isopropyl
alcohol and a soft, clean cloth.