Loepfe YARNMASTER ZENIT+ - Logout Functionality; Access Privilege Reset; Password Management; Password Change Recommendation

11
First Startup Zenit
+
SETTINGS > Machine
8 Check and Complete Base Settings
1. Activate the edit mode by tapping .
2. Check and complete the base settings as follows:
Machine Type Read only
Machine Name Enter name (optional)
MillMaster Link On / Off
Total Spindles Enter total number of
winding units of machine
Yarn Count Unit Select unit (Nm, Ne, Tex, Den)
Sensing Head Type Installed sensing head type
(D, DF, DFP)
Splice Check Length Use default setting
Previous Shift km / kg
> Default Group Settings
6. Use default settings.
7. Return to the overview with .
> Default Data Acquisition
8. Use default settings.
3. Save settings with .
4. Confirm pop-up “Save machine settings!” with .
5. Return to the overview with .
> Base Settings