Need help?Do you have a question about the Loepfe YarnMaster Zenit and is the answer not in the manual?
General| Brand | Loepfe |
|---|---|
| Model | YarnMaster Zenit |
| Category | Industrial Equipment |
| Language | English |
Details how yarn faults are categorized by length and thickness using coordinate systems.
Outlines the capabilities of different YarnMaster Zenit models (Zenit, Zenit F, Zenit FP).
Details the central unit, including touch screen and USB port for interface.
Configures clearer parameters and class settings for yarn clearing via input windows.
Covers initial startup, lot changes, and lot start adjustments for spindle calibration.
Manages user access levels and password settings for system security and data protection.
Covers system parameters like splice check length, total spindles, alarm display, and yarn count selection.
Manages diameter base, fine adjust settings, and special functions like splice check.
Defines limits for yarn clearing channels based on fault types like neps and short faults.
Configures Surface Index (SFI/D) parameters for quality monitoring and detection of irregularities.
Configures Variable CV Channel (VCV) parameters for yarn diameter variations.
Explains foreign matter clearing and configures its class settings based on display modes.
Configures settings for synthetic foreign matter detection using P-sensor sensitivity and reference length.
Provides an overview of cut data counts, splices, and system alarms.
Presents class-based fault analysis, F clearing, mode selection, and data declaration.
Displays AWE status, commands, diameter base, and fine adjust values for diagnosis.
Details spindle adjustment procedures and cut declaration information.
Details textile and technical alarms with their causes and recommended actions.
Outlines routine checks and maintenance procedures for the system components.
Procedures for screen calibration and IP address configuration.
Outlines factory reset procedures and fine adjust value reset.
To Next Page
