ZENIT
57
MONITORING DATA
Selection
Display mode can be selected.
Production
The data of the current production are displayed via the length
specified in Cut Declaration (e. g. the last 1000 km).
Current Shift
Data of the current shift.
Previous shift
Data of the previous shift.
Cut Declaration
Mode
The data acquisition mode (Last, First, Cone) selected in the
Base Settings menu is displayed.
Length (Window Length)
The wound length to which the data refer is displayed.
Last Cut
In the classification per spindle, the last cause of a cut for this
spindle is displayed.
To Next Page
Loading...
