Loepfe YARNMASTER ZENIT+ - Firmware Update Procedure; Navigating to Firmware Update; Firmware Version Verification; Status Indicators for Firmware Versions

First Startup Zenit
+
14
Sensing Head Display
A 1 F 00
E G 00
H 1
with  = class cut without  = channel cut
C 00 D 00
with  = thin place without  = thick place
S 1 R 1
I 1 O 1
with  = bright without  = dark
Nep Joint nep
Short Joint short
Long Joint long
Thin Joint thin
with  = class cut without  = channel cut
flashing display indicates ALARM (selected no. of repetitions reached)
Sensing Head Display
Cut Type
Nep - unclassified Long - unclassified
Short - unclassified Thin - unclassified
Off Count SFI / D
Short Off Count VCV
with  = minus without  = plus
Cluster nep Upper Yarn
Cluster short Bunch
Cluster long
Cluster thin
F (foreign matter) F Cluster
with  = bright without  = dark
P (synthetics)
Zeroing
flashing display indicates ALARM (selected no. of repetitions reached)
Class Type
Yarn runs – Diameter difference _< + / - 10 %
Yarn runs – Diameter difference > + 10 %
Yarn runs – Diameter difference > - 10 %
Technical Alarm (alternating)
Cutter supply or coil failure (alternating)
Internal power supply failure TK (alternating)
No NTP signal (alternating)
Knife blocked (alternating)
Zeroing failed (alternating)
Spindle cycle timeout (alternating)
Class Alarm
Off Limit Alarm
IPI Alarm
Adjust
Doffing
Waiting for spindle communication
Waiting for central unit parameters
Spindle locked, group not started
Reset
Update TK Firmware
Cut by spindle
Zeroing failed
Cut by user (Test / Reset button)
D brightness regulator out of limit
F brightness regulator out of limit
Adjust cut
Cut failed
Adjust failed
Configuration changed by LZE
Spindle power failure
Spindle System Info
System Cuts
Technical Alarms
Textile Alarms
50320003 en