45
1. Change all the batteries to new ones in the low battery sensor(s).
2. Press the SENSOR/WI-FI button on the console to enter sensor synchronization mode (as
indicated by the ashing antenna).
• To reset the console and start again, press the RESET button once or remove the backup
battery and then unplug the adapter.
• To revert back to factory settings and remove all data, press and hold the RESET button
for six (6) seconds.
1. Remove the rubber cup and unscrew the wind cups.
2. Remove the wind cups for the new replacement.
1. Unscrew and remove the wind vane for the new replacement.
1. Unscrew the rain funnel by turning the rain funnel counterclockwise.
2. Gently remove the rain funnel.
3. Clean and remove any debris or insects from the rain funnel.
4. Install the rain funnel when it is clean and fully dried.
• For precision UV measurement, gently clean the UV sensor cover lens with a damp
microber cloth.
• Over time, the UV sensor will naturally degrade. The UV sensor can be calibrated with a
utility-grade UV meter.
PAIRING THE SENSOR(S) MANUALLY
FACTORY RESET
REPLACING THE WIND CUP
REPLACING THE WIND VANE
CLEANING THE RAIN FUNNEL
CLEANING THE UV SENSOR AND CALIBRATION
Whenever you changed the batteries of the 7-in-1 weather sensor or other additional
sensors, re-synchronization must be done manually.
To Next Page
Loading...
