CHAPTER III MACHINE OPERATION
32
2.6.3 BATTERT CHARGING
Do charge the battery following the regulations. Please charge once every three months or start
the engine once every other time, when the machine is parked for long time. Run the machine for some
time to charge the battery fully. After each operation, disconnect the power switch to prevent leakage.
2.6.4 NOTES
2.6.4.1 Electrical lock on the instrument panel should be connected before machine starting and
turned off after engine stopping.
2.6.4.2 After a normal start of diesel engine, do not turn off power switch to avoid the idling voltage
of the generator rising up suddenly , this may burn electrical equipment .
2.6.4.3 Turning off the electrical lock and main switch can avoid accidents under the following
situations.
1
．
When the starting motor adhesion contacts and high current is out of control.
2
．
Repairing cause the circuit ground tapping.
3
．
Electrical devices are short circuit, ground tapping.
4
．
Remember to turn off the power when parking to kee personnels and the machine safe. At the
end of the operation every time, disconnect the power switch to prevent leakage.
Table 5
Electrical system specifications of skid steer loader
System voltage
12V
Battery
120Ah
Single-wire system
Negative earth
Diesel engine starting voltage
Electrical startup, 12V
Refer to the maintenance part." maintenance and precautions of Batteries on the skid steer loader " .
To Next Page
Loading...
