CHAPTER
Ⅰ
SAFETY INFORMATION
14
1.5 OTHER SAFETY INFORMATION
1.5.1 OBSERVE SAFETY INDICATION
1.5.1.1 Before the maintenance and repair , hanging a warning signs on the start switch or control
handle, such as "No action"or other similar warning signs.
1.5.1.2 Know the working width of the machine. When the machine works in the neighbourhood of
the fence or the border barriers, personnels can keep distance of the machine.
1.5.1.3 Take care of high-tension wire and cable buried underground. If the Machine touches
these hazards, personal death or injuries may caused by electric shock .
1.5.2 SAFETY
1.5.2.1 When you operating the machine, do not wear loose clothing or jewelry tthat can snag on
controls or on other parts of the equipment.
1.5.2.2 Make sure that all protective guards and all covers are secured in place on the equipment.
1.5.2.3 Keep the machine free from foreign material. Remove debris, oil tools and other items from
the deck ,from walways, and from steps.
1.5.2.4 Keep the scattered items such as lunch boxes, tools and other items are not machine
parts.
1.5.2.5 Be familiar with special hand signals on the site, only one person should send the hand
signals.
1.5.2.6 Do not smoke when you repair the air conditioning,. Also, do not smoke if refrigerant gas
may be present. Inhaling the fumes that are released from a frame that contacts air conditioning
refrigerant can cause bodily harm or death. Inhaling gas air conditioning refrigerant through alighted
cigarette can cause bodily harm and death.
1.5.2.7 Do not put maintenance oil fluids into glass containers. Discharge all liquids into the
suitable container.
1.5.2.8 Do not operate the machine in the contaminative area. If not, and potential hazards may
exist, should take special action to protect the operator from the danger.
1.5.2.9 If hazards exist, e.g. fragments splashes caused by operating hydraulic hammer, it is
better to assemble the guards or guards that have equal protection effect such as anti-impact materials,
expanded protection and so on.
1.5.2.10 The cab is an important structure to protect the operator. The operator should replace the
cab if plastic deformations or cracking effects take place on the any part of the cab.
1.5.2.11 The use of cleanser should follow the requirements of manufacture. Reporting all the
items need to inspect and repair.
1.5.3 CHECK THE MACHINE
1.5.3.1 Walk around the machine before starting the machine every time. Inspect the machine to
To Next Page
Loading...
