CHAPTER III MACHINE OPERATION
48
Table 7
Ambient temperature Preheating time
Above 10
℃（
50
°
F
）
No need
10
℃（
50
°
F
）
~
－
5
℃（
23
°
F
）
About 5S
Below
－
5
℃（
23
°
F
）
About 10S
Limit for continuous use 20S
（
2
）
When the preheating light is off, turn the electric key to the "start" position and the engine
starts up.
(If the engine can not starts after10S, shut down the engine for 5~30S. Then repeat
（
1
）
and (2)
process again.)
CAUTIOU:When there is fear of temperature dropping below -15
℃（
5
°
F
）
detach the battery form
the machine,and keep it indoors in a safe area,to be reinstalled just before the next operation.
3.5.4 INSPECTION AND MAINTENANCE AFTER OPERATION
3.5.4.1 Check the fuel capacity.
3.5.4.2 Check the oil level and clean of the engine sump,if the oil level is too high and thinning,find
out the reason and excluded it.
3.5.4.3 Check the oil pipe,water pipe and the attachments without leakage.
3.5.4.4 Check the hydraulic pump fixed and sealed, and whether overheating.
3.5.4.5 Check the rim bolts and the pin is fixed.
3.5.4.6 Check the working condition of the device.
3.5.4.7 Check tire appearance and pressure are normal.
3.5.4.8 When the temperature is below 5
℃
, the cooling water should be released, if the antifreeze
is already filled, do not release.
3.5.4.9 Inject every stated injection point with butter on device.
3.5.4.10 Cleaning off dirt and debris of machine and inside bucket.
3.6 STARTING AND PARKING
3.6.1 STARTING
3.6.1.1 Make sure there is no working personnel around the machine before start the machine,
and alarm the horn, to remind people standing around in a safe place.
3.6.1.2 Please check the brake is valid or not before starting the machine.
To Next Page
Loading...
