CHAPTER IV MAINTENANCE SECTION
58
4.1.8.2 Select original parts and components
1
．
The same as oil liquid, the original parts and components are the guarantee of skid steer loader.
it will cost much for the counterfeit.
2
．
You can get lonking special or designated oil, liquid products and original parts and components
from Lonking spare parts company or commission business in various places conveniently.
4.2 MAINTENANCE OF MAIN COMPONENTS
4.2.1 PRECAUTIONS OF DIESEL ENGINE MAINTENANCE
4.2.1.1 See to the details in
《
User Manual
》
selected for the machine.
4.2.1.2 PRECAUTIONS
：
：：
：
1. In the cold weather (the surrounding temperature below freezing point temperature), when
antifreeze is not added to the coolant and the truck need to transport for long distance or shut down,
open the drain switch of diesel engine body, water pump, engine oil cooler, drain switch of radiator
launching room to empty the water preventing freezing.
2. If there is any engine oil in the cooling fluid or any water in the oil sump, should inspect the
machine, replace all of the oil and the water and refill them.
4.2.2 MAINTENANCE OF IMPLEMENT QUIPMENT AND FRAME
4.2.2.1 Regularly inspect the working equipment and whether weldment of frame parts have crack
and bend or not, please repair and replace immediately if there are. For every active part with oil cup,
add lubrication grease to make sure that every active parts flexible and prolong its service life.
4.3 MAINTENANCE AND PRECAUTION OF EQUIPPED ACCUMULATOR SKID
STEER LOADER
Since the battery equipped on the machine, the moving time of new machine is different, the actual
storing power of the battery is different, and the drain power of battery is also different, as a result, pay
attention to the actual storing power of the battery, the storing power of battery is not too low, charge in
time if the power is too low.
4.3.1 MAINTENANCE OF THE BATTERY IN USE
4.3.1.1 Inspect often whether the connection of battery clamp
4.3.1.2 Clean the connection parts of the top with clothes or brush without water,after mounting
the battery, to protect the connection bolts covering vaseline.
4.3.1.3 In the normal working of integrated machines, if stop working in day time or at night, make
sure that all electrical devices turned off normally.
4.3.1.4 During the usual working, the time of using electrical dynamo every time should not be too
long(3-5s), start continually, the interval time should be 10-15s, the times is not too much, three times to
start to run unsuccessfully, find the causes, remove the faults and then start again, prevent leading to
To Next Page
Loading...