Lonking CDM307 - Safety Prompt; Safety Label

CHAPTER Ⅰ SAFETY INFORMATION
2
1.1 SAFETY PROMPT
1.1.1 Only those who experienced special training or got equivalent qualification can operate or
maintain this loader.
1.1.2 Most accidents that involve product operation, maintenance and repair are caused by failure
to observe basic safety rules or precautions.An accident can often be avoided by recognizing potentially
hazardous situations before an accident occurs. A person must be alert to potential hazards. This person
should also have the necessary training, skills and tools to perform these functions properly.
1.1.3 Improper operation, maintenance or repair on this product can be dangerous and could
result in injury or death.
1.1.4 Any modification （ reconfigure ） of this machine without getting the permission of Lonking
may disable the function or effect the safety, and shorten the service life of the machine.
1.1.5 Safety precautions and warnings are provided in this manual and on the machine. If these
hazard warnings are not heeded, bodily injury or death could occur to you or other persons, and cause
economic loss.
1.1.6 The hazards are identified by the "safety Warning Symbol " and followed by a " Warning
Label Word" such as "DANGEROUS","WARNING" or "CAUTION".
1.2 SAFETY LABEL
1.2.1 There are safety labels sticking to machine. This section will give a detailed description for
sticking location and the hazards . Please read and understand those safety labels before operation.
1.2.2 Make sure all the safety labels always are legible and in good conditions; .
1.2.3 Clean or replace the unclear labels.
1.2.4 If the picture on the label is not identified, please replace it.
1.2.5 Clean the labels with soft cloth, water and suds. Do not use solvents, gasoline or other
irritant chemical agents. These cleansers may disable the stickiness of the labels and make the labels
fall off the machine.
1.2.6 Replace any damaged and lost safety labels.
1.2.7 If any part sticking safety label is need of replacement, new safety label need to stick in the
changed part.
1.2.8 Various new safety labels are provided in any Lonking after-service institution.