CHAPTER V HOISTINGAND TRANSPORTATION SECUTING
66
smoothly. Make sure there is enough bearing capacity for the trailer, the truck and
the handling platform to support the machine. Check whether there are some oil
contaminants , ice blocks on the trailer, the truck and the handling platform. Clean
them in time. When drive the machine up and down slowly, do not bias from the truck
to avoid overturning the machine.
5.1.5 Load the machine onto the transporting vehicle as the follow steps. See
the follow figure:
1. Place some wood wedges under the wheels of the truck and the trailer;
2. Secure the ramps on the vehicle, max. angle of obliquity is 15
°
°°
°
. Both ramps must
parallel.
3. Drive the machine carefully, reverse onto the truck.
5.1.6 After driving the machine onto the transporting vehicle, to ensure the
safety during the transportation,it is necessary to protect the machine as the follow
steps. As shown in follow figure:
1. lower the skid steer loader onto the board of the truck. Shut down the engine and move
To Next Page
Loading...
