CDM816D WHEEL LOADER
13
and air.
18.
Check the monitoring instrument for normal
operation.
● ● ● ● ● ● ●
19.
Check the parts for abnormal noise and
overheating.
● ● ● ● ● ● ●
20.
Check the tyres for pressure, crack or
abnormal wear.
● ● ● ● ● ● ●
21.
Check the switch, pedal, handle and button
for normal operation
● ● ● ● ● ● ●
22.
Check the bolts and nuts at all parts for
looseness or shedding.
● ● ● ● ● ● ●
23.
Check especially bolts of rim, drive shaft and
axle bolt for looseness.
● ● ● ● ● ● ●
24.
Remove the pollutants on surface of water
tank and radiator.
● ● ● ● ● ●
25.
Check the fastening bolts of brackets of
transmission and engine.
● ● ● ● ● ●
26.
Check the working device, frame and outer
parts for cracks.
● ● ● ● ● ●
27.
Check t he control levers for flexibility and
apply the lubricating grease.
● ● ● ● ● ● ●
28.
Apply lubricating grease at the hinged points
and hinge pin sleeves.
● ● ● ● ● ● ●
29.
Apply lubricating grease at points such
asdrive shaft and fan shaft.
● ● ● ● ● ● ●
30.
Check the hydraulic oil level and refill if
necessary.
● ● ● ● ● ●
31.
Replace the hydraulic oil filter element, clean
the tank and change the oil.
● ▲ ▲
32.
Check the gear oil level of drive axle or
change the gear oil.
● ▲ ▲ ▲
33.
Check and repair the front and rear axles,
differential and wheel reducer.
●
Always operate the machine as per the label;
otherwise, machine damage or personal
injuries may be caused.
1.5 Other safety i nformation
1.5.1 Compliance with safety instructions
1.5.1.1 Before the maintenance of equipment, hang a safety warning label on the starting switch or
control handle, such as "No Operation".
1.5.1.2 Get to know the width of operating machine to keep a distance with the fence or boundary
obstacle when working around them.
1.5.1.3 Beware of the buried high-voltage wires and cables. The crash between the machine and
these dangerous objects may cause casualties due to an electric shock.
1.5.2 Safety precautions
To Next Page
Loading...
Need help?
General
