CDM816D WHEEL LOADER
31
Fig. 2-3 Working device control
II. New vehicle running-in
The new vehicle must first undergo a running-in period and during this period, use and maintenance
shall be paid attention to according to the following specifications.
(i) Notes on new vehicle running-in
1. The new loader shall be subject to a running-in period for a total of 12 hours in a manner of two
forward gears and two reverse gears applied uniformly.
2. During the running-in period, the loading/unloading load shall not exceed 70% of the rated load.
3. Pay attention to the lubrication conditions and change or add grease at the specified time.
Stop
Release
Fig.2-2 Hand brake control
Floating
Lowering
Boom control lever in
neutral position
Lifting
Bucket tilting
forward
Tilt control lever in
neutral position
Bucket tilting
backward
To Next Page
Loading...
