Why is the ground cable connector on my LORCH M-Pro Performance M 300 becoming hot?
If the ground cable connector on your LORCH Welding System becomes hot, check that the connector was locked by turning clockwise.
Why is the control panel completely dark on my LORCH M-Pro Performance M 300 Welding System?
If the control panel of your LORCH Welding System is completely dark, a phase might be missing. Check the equipment at a different power socket, and inspect the supply cable and mains fuse.
How to prevent my LORCH M-Pro Performance M 300 Welding System torch from becoming too hot?
If the torch of your LORCH Welding System becomes too hot, check that the contact tip is tightened properly.
Why is the wire feed on my LORCH Welding System irregular or failing?
If the wire feed on your LORCH Welding System is irregular or has failed, there are several potential causes: * Incorrect contact pressure on the wire feed unit. Adjust the pressure as detailed in the operating instructions. * A faulty torch. Inspect the torch and replace it if necessary. * A missing or dirty guide tube in the central socket. Insert the guide tube or clean it. * A badly wound welding wire reel. Check the reel and replace it if necessary. * Surface rust on the wire electrode. Check the electrode and replace if necessary. * A torch internal coil clogged with abrasion dust. Unscrew the torch, remove the contact tip, and blow out the coil with compressed air. * A flexed torch internal coil. Check the coil and replace it if necessary. * A wire brake setting tha...
Guide for connecting the welding torch to the central socket.
Instructions for connecting the welding return cable and ground clamp.
Overview of the welding machine's control panel and its components.
General| Brand | LORCH |
|---|---|
| Model | M-Pro Performance M 300 |
| Category | Welding System |
| Language | English |
To Next Page
