page 27
Change from pc-board DRV0x toe DRV1x
Since week 18 2017 the new DRV boards are used in the MicorMIG series. To ensure the multivoltage function
and generator useage, not only the hard and software of the DRV were changed, also the software of the MAPRO
board (version 2.02 for Master and Process rmware) needed to be changed.
That is why the new DRV boards are NOT compatible with the MAPRO software 1.xx.
If a “old” DRV0x board needs to be replaced by a “new” DRV1x board, it is absolutely necessary that
the MAPRO needs to be updated to minimum version 2.02!!!
previous board replaced by new part no.
DRV03 DRV13 981.1219.0
DRV05 DRV15 650.5645.5
DRV07 DRV17 650.5647.5
To Next Page
Loading...
