LORD D4 - Filling The Rinse Aid Reservoir; Adjusting the rinse aid reservoir

13
Filling The Rinse Aid Reservoir
3
1


Removetherinsereservoircapbylifting
upthehandle.
Pourtherinseaidintothedispenser,
beingcarefulnottooverll.
Closethecapafterall.
Adjusting the rinse aid reservoir
Toachieveabetterdryingperformancewithlimitedrinseaid,thedishwasheris
designedtoadjusttheconsumptionbyuser.Followthebelowsteps.
1. Closethedoorandswitchontheappliance.
2. Within60secondsafterstep1,presstheprogrambuttonmorethan5seconds,
andthenpresstheDelay„+“buttontoenterthesetmode,therinseaidindication
blinksas1Hzfrequency.
3. PresstheProgrambuttontoselectthepropersetaccordingtoyourusinghabits,
thesetswillchangeinthefollowingsequence:D1->D2->D3->D4->D5->D1.
 Thehigherthenumber,themorerinseaidthedishwasheruses.
4. Withoutoperationin5secondsorpressthePowerbuttontocompletethesetup
andexitthesetupmode.