LORD D4 - Water Supply And Drain

16
Water Supply And Drain
Cold water connection
Connectthecoldwatersupplyhosetoathreaded3/4(inch)connectorandmakesure
thatitisfastenedtightlyinplace.Ifthewaterpipesareneworhavenotbeenusedfor
anextendedperiodoftime,letthewaterruntomakesurethatthewaterisclear.This
precautionisneededtoavoidtheriskofthewaterinlettobeblockedanddamagethe
appliance.

ordinarysupplyhose
safetysupplyhose
About the safety supply hose
Thesafetysupplyhoseconsistsofthedoublewalls.Thehose‘ssystemguaranteesits
interventionbyblockingtheowofwaterincaseofthesupplyhosebreakingand
whentheairspacebetweenthesupplyhoseitselfandtheoutercorrugatedhoseisfull
ofwater.

WARNING
Ahosethatattachestoasinkspraycanburstifitisinstalledonthesamewaterlineas
thedishwasher.Ifyoursinkhasone,itisrecommendedthatthehosebedisconnected
andtheholeplugged.
How to connect the safety supply hose
1. PullThesafetysupplyhosescompletelyoutfromstoragecompartmentlocatedat
rearofdishwasher.
2. Tighterthescrewsofthesafetysupplyhosetothefaucetwiththread3/4inch.
3. Turnwaterfullyonbeforestartingthedishwasher.
How to disconnect the safety supply hose
1. Turnothewater.
2. Unscrewthesafetysupplyhosefromthefaucet.