LORD D4 - Changing The Program Mid-cycle; Forget To Add A Dish?

17
Changing The Program Mid-cycle
Awashcyclecanonlybechangedifithasbeenrunningforashorttimeotherwise,
thedetergentmayhavealreadybeenreleasedandthedishwashermayhavealready
drainedthewashwater.Ifthisisthecase,thedishwasherneedstoberesetandthe
detergentdispensermustberelled.Toresetthedishwasher,followtheinstructions
below:
1. PresstheStart/Pausebuttontopausethewashing.
2. PressProgrambuttonformorethan3seconds-theprogramwillcancel.
3. PresstheProgrambuttontoselectthedesiredprogram.
4. PresstheStart/Pausebutton,thedishwasherwillcontinuedtorunafter10seconds.

Forget To Add A Dish?
Aforgottendishcanbeaddedanytimebeforethedetergentdispenseropens.
Ifthisisthecase,followtheinstructionsbelow:
1. PresstheStart/Pausebuttontopausethewashing.
2. Wait5secondsthenopenthedoor.
3. Addtheforgottendishes.
4. Closethedoor.
5. PresstheStart/Pausebutton,thedishwasherwillcontinuedtorunafter10seconds.
 
After5sec

WARNING
Itisdangeroustoopenthedoormid-cycle,ashotsteammayscaldyou.