Pan/Tilt/Zoom (PTZ) Cameras19
NOTE
Ensure you have completed initial setup of your PTZ camera in order to control the camera using the recorder. See
19.1 Connecting PTZ Cameras to the Recorder for more details.
To access the advanced PTZ controls:
• Open the Live View screen for your PTZ camera in single-channel view (fullscreen). Right-
click to open the Quick Menu, then click Pan/Tilt/Zoom.
• Click the arrow on the far-right side of the PTZ control panel to access advanced options.
• Right-click again to close PTZ controls.
To use advanced PTZ controls:
NOTE
Depending on your PTZ camera model, some of the features in the advanced menu may not be supported. Refer to
your camera documentation to confirm which features are supported by your camera.
1. No.: Enter the ID number for a preset, tour, or pattern you want to activate.
2. Preset: Move the camera to the preset number specified in the No. field. For instructions on
setting up preset locations, see 19.4 Presets, page 101.
3. AutoPan: Set the camera to rotate 180° back and forth.
4. Tour: Perform the tour number specified in the No. field. For instructions on creating a tour,
see 19.5 Tours, page 102.
5. Flip: Rotate the camera 180° from its current position.
6. Pattern: Perform the pattern number specified in the No. field. For instructions on creating a
pattern, see 19.6 Patterns, page 102.
7. Reset: Move the camera to the home position.
8. AutoScan: Move the camera between a predetermined left and right point. For instructions on
creating an autoscan, see 19.7 AutoScan, page 102.
9. Configuration: Click to open the configuration menu, where you can configure presets, tours,
patterns and autoscans.
10. OSD Menu: Click to open the camera’s OSD menu. This may not be supported on all camera
models.
11. Auxiliary Settings: Not supported.
19.4 Presets
Presets will save a camera position for quick retrieval.
#LX400113; r. 1.0/56015/56022; en-US 101
To Next Page
Loading...
Need help?
General
