7
Installing the Wireless Receiver
ENGLISH
5. Installing the Wireless Receiver
Before powering on the receiver, make sure to first connect and
power on the cameras. This will ensure a proper connection.
1 Connect the two BNC cables from the wireless receiver to your DVR.
2 Connect the power cable to the power adapter. Plug the power adapter into a power outlet or
surge protector.
3 Place the receiver in a place that will have clear reception to your cameras
1
.
NOTE: If one of your c
ameras is out of range, the corresponding channel indicator LED
will flash on and off rapidly.
OPTIONAL: Use the included double-sided tape to secure the receiver to a surface (e.g.
wall).
1. Avoid installing in a location which requires the wireless signal to pass through cement, con-
crete, and metal structures. This will reduce the range of transmission.
To Next Page
Loading...
Need help?
General
