I336 GB I 05 13 31100162
32
G
B
ALARM TABLE
CODE DESCRIPTION DEFAULT ALARM PROPERTIES
A01 Engine temperature warning (analog sensor)
A02 High engine temperature (analog sensor)
A03 Analog temperature sensor fault
A04 High engine temperature (digital sensor)
A05 Low engine temperature (analog sensor)
A06 Oil pressure prealarm (analog sensor)
A07 Low oil pressure (analog sensor)
A08 Analog pressure sensor fault
A09 Low oil pressure (digital sensor)
A10 Digital pressure sensor fault
A11 Fuel level prealarm (analog sensor)
A12 Fuel level low (analog sensor)
A13 Analog level sensor fault
A14 Fuel level low (digital sensor)
A15 High battery voltage
A16 Low battery voltage
A17 Inefficient battery
A18 Battery alternator fault
A19 “Pick-up/W” signal fault
A20 “Pick-up/W” engine speed low
A21 “Pick-up/W” engine speed high
A22 Starting failed
A23 Emergency stopping
A24 Unexpected stop
A25 Engine stopping failure
A26 Low generator frequency
A27 High generator frequency
A28 Low generator voltage
A29 High generator voltage
A30 Generator voltages asymmetry
A31 Max. generator current
A32 Generator short-circuit
A33 Generator overload
A34 Generator external protection intervention
A35 Generator kW threshold exceeded
A36 Generator earth fault
A37 Generator phase sequence error
A38 Mains phase sequence error
A39 System frequency settings error
A40 Generator contactor anomaly
A41 Mains contactor anomaly
A42 Maintenance request 1
A43 Maintenance request 2
A44 Maintenance request 3
A45 System Error
A46 Tank too empty
A47 Tank too full
A48 Rent hours expired
A49 Radiator coolant level low
A50 Manual circuit breaker closed
A51 Manual circuit breaker open
A52 Battery charger alarm
A53 CANbus red lamp alarm
A54 CANbus yellow lamp alarm
A55 CANbus error
A56 Fuel theft
A57 Cannot change configuration
A58 Water in fuel
A59 Fuel filling pump failure
UA1 UA1
UA2 UA2
UA3 UA3
UA4 UA4
UA5 UA5
UA6 UA6
UA7 UA7
UA8 UA8
Enabled
Retained
Glob. Al.
Fault
Fault
Siren
Engine
Cooling
Motor
Inhibit.
Modem
No LCD
To Next Page
Loading...
Need help?
General
