193
7. The Map Page appears, with the cursor pointing to the found intersec-
tion. The intersection in our example is shown in the following figure.
Map Page showing results of an intersection search.
The cursor points to the located intersection.
If you want to navigate to the found intersection, just press
MENU|ENT|EXIT.
Find Waypoints
1. Press WPT|ENT.
2. If searching for the waypoint By Name, press
ENT. If searching for
the Nearest waypoint, press ↓ to
NEAREST|ENT. (To search by name,
jump to step 5.)
Find Waypoint menu, left; Find By Nearest command, center,
Find by Name command, right.
3. If you're looking for nearest, the unit says it is calculating, then a list
of waypoints appears. The closest waypoint is highlighted at the top of
the list. The waypoint furthest from you is at the bottom of the list.
4. To see location information on the closest (highlighted) waypoint,
press
ENT and the Waypoint screen appears. (If you wanted to, you
could select another waypoint from the list with the ↑ or ↓ keys.)
To Next Page
Loading...
Need help?
General