L-Switch User Manual 25 LOYTEC
Version 6.0 LOYTEC electronics GmbH
5 User Interface
5.1 Status Button
The L-Switch XP is equipped with a status button (see Figure 1). When pressing the status
button shortly during normal operation of the L-Switch XP, it sends a “Service Pin
Message” on every port. Note, that every L-Switch XP port has its own unique node ID
(“Neuron ID”).
Pressing the status button longer than 2 seconds will allow you to select the port to sends
out the “Service Pin Message” message: The port LED of the currently selected port will
light up orange. After 2 seconds the next available port will be selected. When the status
button is released the “Service Pin Message” is sent out on the currently selected port.
If the L-Switch XP is operated in smart switch mode (see Section 4.1.1) or repeater mode
(see Section 4.1.2) pressing the status button for more than 20 seconds resets the switching
tables (see Section 5.5).
5.2 LED Signals
5.2.1 Status LED
The L-Switch XP is equipped with a two-color status LED (green and red, see Figure 1).
When power is applied to the L-Switch XP, the status LED is green. During boot-up the
status LED is used to signal error conditions (red).
5.2.2 Port LEDs
Each port on the L-Switch XP has a three color LED (green, red and orange, see Figure 1).
Table 11 shows the port different LED patterns and their meaning.
To Next Page
Loading...
