Setting up
CG-6 Operation Manual p/n 115370001 Rev A
Figure 3-21 The measure length screen
The measurement length can be set to either 30 seconds, 60 seconds or 120 seconds.
To exit this screen, move the cursor to CANCEL and press the Enter
Entering a record delay value
You can enter a record delay value, in seconds, which will delay the start of the recording
of data. This is convenient when operating in the field or during a drift test when you want
to delay the start of a reading. To edit the value of the record delay, move the cursor to
Record Delay and press the Enter button. The following screen will appear:
Figure 3-22 The record delay editing screen
The record delay can be set to any value between 0 and a large number of your
choosing. To enter the record delay value, move the cursor to the chosen character and
press the Enter button. To clear the entire field, move the cursor to the CLEAR field and
press the Enter button. To clear the last character that was entered, move the cursor to
the Backspace field and press the Enter button. Once you are satisfied with the value of
the contrast, move the cursor to the ACCEPT field and press the Enter button. To exit
this screen, move the cursor to CANCEL and press the Enter button.
Recording the Raw tsf file
To Next Page
Loading...
Need help?
General