2
) Beep continuously.
To turn Alphanumeric Guest Paging Vibration On or O
ff:
Select 2) Alphanumeric Vibe.
Press F1 (yes) to turn Alphanumeric Vibration On of F2 (No) for Off.
Manager Pager - Select:
1) Vibe 1 time.
2) Vibe 2 times.
3) Vibe 3 times.
F2 (ON)
1) Vibe continuously.
2) Vibe/Beep 1 time.
3) Vibe/Beep 2 times.
F2 (ON)
1) Vibe/Beep 3 times.
2) Beep 3 times.
3) Beep continuously.
Set to Page Staff or Guest Pagers
In cases where the unit will always be paging staff pagers, the transmitter default can be set to page either
Guest or Staff pagers. Factory default is Guest:
1. Press SETUP and enter Password.
2. Select 1 (1: Default Mode).
3. Select 1 (Guest Paging) for guest pager or 2 (Staff Paging) for staff pager.
Create Alphanumeric Messages
If your staff pagers are alphanumeric, they can display 77 different pre-set messages (numbered 000 through
076), and 22 additional user-defined messages of up to 32 characters per message (077 through 099).
1. Press SETUP and enter Password.
2. Press 3) Other.
3. Press 1) Canned Message.
4. At the Canned Msg.# screen select F3 (EDIT) to edit message, (use (F1 (up) or F2 (DN) to scroll
through messages to edit).
5. If no message exists at the Edit Message screen, type a new message. If a message exists, press
F3 (EDIT) to change it. Enter the desired message using the number keys, waiting until the cur-
sor moves between letters (i.e. for letter ‘E’ press #2 twice). Similar to a Cell Phone.
6. Press the ENTER key to save your message.
Long Range Systems 16 T7470 User Manual
To Next Page
