LS ELECTRIC LSLV-G100 Series - Grounding the PROFIBUS-DP Communication Module

LSLV-G100 PROFIBUS-DP Communication Module
6
• Do not install or remove the communication module to or from the G100 inverter while
the inverter is turned on.
• Install or remove the communication module to or from the G100 inverter only after
the electric charge of the capacitor inside the inverter has been completely
discharged.
• Ensure that the cable connection between the module and the inverter (dedicated RJ-
45 cable) is not loose or disconnected.
Grounding the PROFIBUS-DP communication module
Follow the instructions below to ground the communication module using a ground
cable (shielded cable). The ground cable is not included in the product package.
1 Remove the front cover from the communication module.
2 Fix the ground cable to the communication module using the bottom screw on the circuit
board.
3 Remove the knockout panel with the grounding symbol from the front cover.
4 Install the front cover to the communication module.