LS ELECTRIC LSLV-G100 Series - Number of Para Status Settings

Inverter Parameters
14
4.2.4 Number of Para Status settings
CM-30
Number of Para Status settings
CM-31
~
CM-38
Para Status1–8 settings
CM-94
Comm Update
The parameters above are used to determine how much "Para Status" data will be
sent to the master device by the inverter through PROFIBUS-DP network
communication.
The number of the "Para Status" can be set to a number between 0 and 8.
After setting the number of "Para Status," each "Para Status" has to be set using the
matching number of parameters from CM-31 to CM-38. For example, if CM-30 is set
to "3," "Para Status" should be set for CM-31 to CM-33. If CM-30 is set to "6," the
"Para Status" should be set for CM-31 to CM-36.
After changing the number of "Para Status," you must set "CM-94 (Comm Update)" to
"1" to apply the changes to the PROFIBUS-DP communication module.