LSLV-G100 PROFIBUS-DP Communication Module
2.4 Installation
Turn off the inverter before configuring the communication network.
Both the inverter and the communication module will be damaged if the
communication module is installed or removed while the inverter is turned on. Install
or remove the communication module after the capacitor inside the inverter is
completely discharged.
1 Get the G100 PROFIBUS-DP communication module ready for installation. (A dedicated
RJ-45 cable is attached to the module.)
2 Remove the front cover from the G100 inverter.
3 Connect the communication module to the G100 inverter using the RJ-45 network cable.
4 Hook up the communication module to the installation slot on the inverter.
5 Install the fixing bolt provided with the communication module using an appropriate tool.
6 The PROFIBUS-DP communication module has been installed on the G100 Inverter.
To Next Page
Loading...