LS ELECTRIC LSLV-G100 Series - PROFIBUS-DP Communication Parameters; Station ID Setting

Inverter Parameters
12
4.2 PROFIBUS-DP Communication Parameters
4.2.1 Communication module Version
CM-06 is used to display the version of PROFIBUS-DP communication module
installed on the inverter.
4.2.2 Station ID Setting
The following parameters are used to set the Station ID for the PROFIBUS-DP
communication module.
CM-07
FBus ID
CM-94
Comm Update
The parameters above are used to set the Station ID for the PROFIBUS-DP
communication module. A Station ID can be set to a value within a range of 1–125.
The station ID cannot be duplicated. Make sure the same Station ID is not used by
another module in the network.
After changing the Station ID, you must set "CM-94 (Comm Update)" to "1" to apply
the change to the PROFIBUS-DP Communication module.