Chapter 7. Usage of Various Functions
7-81
(2) Speed Control (Uniform Speed Operation)
• This controls the speed by the setting speed until deceleration stop command(POSCTR) is entered after execution by
POSVEL command..
• The speed can be changed by the speed override instruction(POSSOR)
• Speed control contains 2 types of start method : Forward direction start and Reverse direction start.
- Forward direction : when position address is positive number (+) (“0” included)
- Reverse direction : when position address is negative number (-)
Forward direction Reverse direction
Set second operand of POSVEL instruction to 0
Set second operand of POSVEL instruction to 1
• Timing diagram
Please refer to the section ‘POSVEL’ for details.
(3) Synchronization control
• After the execution of POSSYNC, the HSC input pulse speed is synchronized by the designated synchronization
scale.
• Scale can be changed during the execution.
• Setting range: 0 ~ 100%
Speed
On
Time
On
Setting speed
Dwell time
Deceleration stop command
(POSCTR)
Speed control command
(POSVEL)
REMARK
Scale =
Positioning speed
HSC input speed
To Next Page
Loading...
