Chapter 7. Usage of Various Functions
7-119
Remark
1) The rated input for the origin of GM7U is DC 24V. Line driver output, wire a DC SSR and return to origin by DOG
signal or using a origin sensor of original signal.
2) Input points for origin, approximate origin point, and upper/lower limit signal are fixed but, if they’re not used you
able to use them general input point. You can use emergency stop with the command (POSCTR)
3) Using DC 24V, wire a proper resistor(1.5K, 1/2W) to driver in series.
4) Positioning phase of GM7U is as follow: Set the input mode of a step mode driver to 1 phase input mode
because motor operation mode is determined by rotating direction input.
To Next Page
Loading...
