3 -4
3
4WD indicator (Not used)
4
PTO operation indicator
2
Quick turn indicator (Not used)
6
Engine coolant temperature gauge
z This gauge indicates the temperature of coolant during operation.
z The closer the needle approaches “H”, the higher the temperature of engine coolant is.
z The coolant is very hot. When checking the coolant, comply with instructions of the section 5,
“Maintenance and Lubrication” in this manual.
5
One side brake indicator (Not used)
z When key switch is ON and PTO switch is ON ,
this indicator shall be ON.
(For further information, See section 3-1-(9))
3
2
4
5
6
7
7
Cold start aid indicator
z If the cold start aid device is working, this indicator shall be ON. After the indicator is OFF, start the
engine.
8
Engine warning indicator
9
High beam indicator
10
Turn signal indicator (Left / Right)
z When turning on high beam of the headlamp,
This indicator shall be ON simultaneously.
z When the front/rear turn signal lights are blinked,
This indicator shall be blinked simultaneously.
8 109
z If there is a fault on the engine control, this
indicator shall be ON with continuous light or be
blinking alone.
Contact your authorized dealer for check.
z If this indicator and DPF regeneration indicator
are blinking together, refer to the instructions of
the DPF regeneration indicator. (See page 3-14)
z This indicator is not used.
1
Forward-reverse indicator (Not used)
To Next Page
Loading...
Need help?
General
