3-4. Safety device
(1) Seat belt
Always wear the seat belt before operating the tractor and adjust the belt to fit the operator.
1. Insert the seat belt end into the buckle until a ‘click’ indicates it is properly engaged.
2. To remove the seat belt from the buckle, press the red release button on the buckle.
Check the seat belt regularly. If damaged or frayed, replace it with a new one.
Warning
▶
If not wearing the seat belt, it may cause serious injury in case of accident.
- During operation, it must be required to wear seat belt with a cab or safety frame
installed.
- After wearing the seat belt, adjust the belt to fit the operator.
▶
If safety frame is folded down for frame model, do not wear the seat belt.
(2) Safety frame (R.O.P.S type)
How to fold the safety frame
1.Unfasten the safety frame bolts
①
,
②
(both sides)
loosely. (do not remove it completely.)
2.Loosen the pin (both side) slightly and fold it down.
Be careful of the possibility that your head, hand
or shoulder might be hurt by sudden folding
results from the weight of the safety frame at this
moment.
3.Fit the pin into the hole in order to fix the safety
frame.
4.Fix it completely by fastening the safety frame
bolts
①
,
②
tightly.
After standing the safety frame up again, fasten
bolts and nuts tightly.
bolt
①
Pin
bolt
②
3
3 3
3 - 22
Warning
▶
Do not change or disassemble the safety frame arbitrarily for safety.
▶
Unless the safety frame is applied correctly, it may cause a serious accident on
tractor when being overturned.
- Be sure to stand the safety frame up completely and assemble the bolts, pins and
nuts in correctly.
▶
In case of folding the safety frame.
- Do cooperate with more than 2 people when folding or standing up the safety
frame as it’s heavy.
- Be careful not to be injured by sudden folding, which might occur when folding or
standing up the safety frame, results from its weight.
- Do not wear seatbelt when the safety frame is folded down.
- Do stand the safety frame up again as soon as the work is finished.