LSIS H100 - User Manual

2 pages

To Next Page

LSIS H100 Quick Start Guide

1 LS H100 Quick Start Guide

Rev I_6-19-2017

1. H100 Basic Setup Parameters

The basic drive and motor parameters are shown in Table 1. Set the parameters according to your application.

Table 1. H100 Basic Setup Parameters

Note: Many applications will not require changes to the basic setup parameters from their default values.

1.1 H100 Recommended Additional Parameter Changes

The H100 drive has some default settings the user may want to change to obtain better protection of the

drive/motor and the application. These changes are recommended, but not needed for all applications.

Auto Reset

• Program CON 71 bit 3 to High State (0100).

• Program PRT 08 (Reset/Restart after a fault) to “1” (Yes).

• Program PRT 09 (Number of Retries) to a number between 0 -10.

• Program PRT 10 (Auto Reset Time) to desired time to allow cause of fault to clear and safe starting.

Start on Power Loss

• Program ADV 10 (Power on Start) to “1” (Yes).

Phase Loss

• Program PRT 05 (Phase Loss) to detect input and/or output phase loss.

Note: This parameter is displayed as DIP switches on the H100. Left bit is the Input, Right bit is the Output.

2. HP to kW Conversion Table

Use the following conversion table to enter the motor HP. Select the closest size the drive allows in kW (motor

power is in kW on most LSIS drives)

Other manuals for LSIS H100

General

Overload Capacity	150% for 60 seconds
Braking Unit	Built-in
Control Method	V/F Control, Sensorless Vector Control
Cooling Method	Forced Air Cooling
Altitude	Up to 1000m without derating
Input Voltage	380V - 480V
Input Frequency	50Hz/60Hz
Output Voltage	0 to Input Voltage
Output Frequency	0.1 to 400Hz
Protection Functions	Overvoltage, Undervoltage, Overcurrent, Overload, Overtemperature, Short Circuit
Communication	RS485 (Modbus RTU)
Operating Temperature	-10 to 50°C
Storage Temperature	-20°C ~ +65°C
Humidity	5% to 95% RH (non-condensing)