5. Programming Keypad
5.6 Monitoring of Operation Status
Monitoring output current in Drive group
Drive group
1
-. In [0.0], continue pressing the Up () or Down () key
until [Cur] is displayed.
2
-. Monitoring output current is provided in this parameter.
-. Press the Prog / Ent (
) key once to check the current.
3
-. Present output current is 5.0 A.
-. Press the Prog / Ent (
) key once to return to the
parameter name.
4
-. Return to the output current monitoring code.
♣ Other parameters in Drive group such as dCL (Inverter DC link current) or
vOL (Inverter output voltage) can be monitored via the same method.
To Next Page
Loading...
Need help?
General
