LSIS SV008iC5-1F User Manual

7. Function List
7-8
7.3 Function Group 2
LED
display
Parameter
name
Min/Max
range
Description
Factory
defaults
Adjustable
during run
Page
H 0 [Jump code] 1/95  This parameter sets
the code number to jump.
1 O
H 1
[Fault
history 1]
-

This parameter stores
information on the types
of faults, the frequency,
the current and the
Accel/Decel condition at
the time of fault.
 The last fault is
automatically stored in
the H 1- [Fault history 1].
nOn
-
H 2 [Fault
history 2]
-
nOn
-
H 3
[Fault
history 3]
-
nOn
-
H 4 [Fault
history 4]
-
nOn
-
H 5
[Fault
history 5]
-
nOn
-
H 6 [Reset fault
history]
0/1  This parameter clears
the fault history saved in
H 1-5.
0 O
H 7
[Dwell
frequency]
F23/400
[Hz]

When run frequency is
issued, motor starts to
accelerate after dwell
frequency is applied to
the motor during H8-
[Dwell time].
 [Dwell frequency] can
be set within the range of
F21- [Max frequency] and
F23- [Start frequency].
5.0
X
H 8 [Dwell time] 0/10
[sec]
 This parameter sets the
time for dwell operation.
0.0 X
H10
[Skip
frequency
select]
0/1

This parameter sets the
frequency range to skip to
prevent undesirable
resonance and vibration
on the structure of the
machine.
0
X
H11
1)
[Skip
frequency
low limit 1]
0/400
[Hz]
 Run frequency cannot
be set within the range of
H11 thru H16.
 The frequency values
of the low numbered
parameters cannot be set
above those of the high
numbered ones.
10.0 X
H12
[Skip
frequency
high limit 1]
15.0
X
H13 [Skip
frequency
low limit 2]
20.0 X

LSIS SV008iC5-1F Specifications

General

Brand	LSIS
Model	SV008iC5-1F
Category	DC Drives
Language	English