LSIS SV008iC5-1F - I;O Group: Current Input and Multi-function Terminals

7. Function List
7-17
LED
display
Parameter
name
Min/Max
range
Description
Factory
defaults
Adjustable
during run
Page
I13 [Frequency
corresponding
to I 12]
0/400
[Hz]
 Set the inverter output
minimum frequency at minimum
current of I input.
0.0 O
I14 [I input max
current]
0/20
[mA]
 Set the Maximum Current of I
input.
20 O
I15 [Frequency
corresponding
to I 14]
0/400
[Hz]
 Set the inverter output
maximum frequency at maximum
current of I input.
60.0 O
I16 [Criteria for
Analog Input
Signal loss]
0/2
0 Disabled 0 O
1
Less than half the value set
in I 2/7/12 entered
2
Below the value set in I
2/7/12 entered
I20 [Multi-function
input terminal
P1 define]
0/24 0 Forward run command {FX} 0 O
1
Reverse run command {RX}
I21 [Multi-function
input terminal
P2 define]
2 Emergency Stop Trip {EST} 1 O
3
Reset when a fault occurs
{RST}.
I22 [Multi-function
input terminal
P3 define]
4
Jog operation command
{JOG}
2 O
5 Multi-Step frequency – Low
I23 [Multi-function
input terminal
P4 define]
6 Multi-Step frequency – Mid 3 O
7 Multi-Step frequency – High
I24 [Multi-function
input terminal
P5 define]
8 Multi Accel/Decel – Low 4 O
9 Multi Accel/Decel – Mid
10 Multi Accel/Decel – High
11 DC brake during stop
12 2
nd
motor select
13 -
14 -
15
Up-down
operation
Frequency
increase
command
(UP)