Setpoints
MXD70 Setpoints, Current Outputs,
and Digital Inputs Configuration Guide
- 19 -
Setpoints
Clean Delay
If enabled this causes the clean cycle to wait if any
other control setpoints associated with the sensor
input channel are active. This is shown by a clean
delayed message on the front screen.
/ – Select Option
EXIT
– Cancel
– Save Selection
Manual Clean
This manually starts a clean cycle.
Note this can also be accomplished via the digital
inputs, see Digital Inputs section.
/ – Select Option
EXIT
– Cancel
– Save Selection
To Next Page
Loading...
Need help?
General
