Lucent Technologies Galaxy Power System 4812
Issue 5 June 2000 Galaxy Controllers 3 - 7
Galaxy Vector Controller, continued
Pushbutton Keys Pushbutton keys around the backlit LCD display provide the primary
user interface with the controller. These keys are used singly or in
combination to navigate through the controller’s menus.
The following is a general description of the pushbutton keys:
• VOLTS or AMPS: Select either volts or amps for viewing.
• BOOST or FLOAT: Select one of these system modes.
• BATTERY TEST: Start/stop discharge test.
• ACO: Switch between Alarm Cut Off and On. The LED lights
when audible Alarm Cutoff is active.
• VIEW ACTIVE ALARMS: Display active alarms. Use the arrow
keys to page through multiple alarms. The LED lights when this
option is selected. Note: View Active Alarms and Configure
cannot be active simultaneously.
• CONFIGURE: Enter Configuration Mode. The LED lights when
this option is selected. Note: Configure and View Active Alarms
cannot be active simultaneously.
• ENTER: Select a menu item.
• DEFAULT: In Configure mode, change a parameter to default
value.
• ESCAPE: Return to the immediate higher level menu.
• Up arrow: Moves the cursor up one line.
• Down arrow: Moves the cursor down one line.
• Left arrow: Moves the cursor left one field.
• Right arrow: Moves the cursor right one field.
• ADJUST + and -: Increase or decrease parameter values.
• LAMP TEST: Tests the controller’s circuit board LEDs and front
panel LEDs. It will also test the indicators of serially connected
rectifiers.
To Next Page
Loading...
Need help?
General
