Installation
14
6 Insert the 3-1/2” #8 screw into the
bottom of the modules. Tighten it
until the mounting tracks of the
PARTNER ACS processor
module are flush against the wall
with a 3/8” (1 cm.) gap between
the wall and the rest of the
PARTNER ACS processor
module. Do not overtighten or the
module will warp.
7 a. Label the lines and extension
jacks as shown.
b. Connect modular phone cords
to the extension jacks, starting
at the top extension jack on the
PARTNER ACS processor
module.
c. Route each cord through the
hook on the front of its module.
d. Connect the free end of each
phone cord to the modular wall
jacks for system extensions.
8 a. Attach one end of a #12 AWG
or #14 AWG solid copper wire
to the grounding screw on the
primary processor module.
Note that the length of the wire
must not exceed 35 feet (7.6
meters).
b. Route the wire through the
hook on the front of the
module.
c. Attach the other end of the
wire to the approved earth
ground, such as building steel
or cold water pipe.
L
I
N
E
S
E
X
T
E
N
S
I
O
N
S
PFT
PARTNER
3000
To Next Page
Loading...
