Installation Procedures
15
9 Press the power cord firmly into the power jack on the carrier. Plug the other
end of the power cord into a properly grounded three-prong wall outlet not
controlled by a switch.
!
CAUTION:
The power cord should hang straight down from the connector, flush against
the plastic case for the entire length of the board. Do not install the power
cord at an angle to the case or with a loop in it.
10 Check the green lights on the fronts of the modules.
a. If a single light is out, power down the carrier, reseat the module, then
power up the carrier.
b. If both green lights are out, power down the carrier, reseat both modules,
then power up the carrier.
c. If the lights are still out, in the continental U.S. call your local Authorized
Dealer or the Lucent Technologies Technical Service Center at
800-628-2888. Outside the continental U.S., contact your Lucent
Technologies Representative or local Authorized Dealer.
11 Continue with “Inserting Batteries in the PARTNER ACS Processor
Module.”
To Next Page
Loading...
