Lucent Technologies PARTNER Advanced Communications System - Page 32

Installation
26
2 a. Connect line cords to the line
jacks on the PARTNER ACS
processor module and the
308EC, 206, and 400
modules. Start at the top with
the line jacks on the
PARTNER ACS processor
module, and then move to the
leftmost 308EC or 206
module. Fill each module
before moving to the next
module to the right.
b. Route each cord through the
hook on the front of the
module.
3 Connect the free end of each line
cord to the appropriate network
interface jack.
4 a. Test the lines—plug a system
phone into extension jack 10.
Press the line buttons for each
outside line and listen for a dial
tone.
b. Repeat for the first extension
on each module.
1
2
3
10
11
12
14
15
16
17
13
11
12
14
15
16
17
13
555-
13
555-1347
555-1348
555-1349
COM
BO
COMBO
C
OMBO
COMBO
COMBO
COMBO