Installation Procedures
27
5 a. Connect modular telephone cords
to the extension jacks, starting at
the top extension jack on the
PARTNER ACS processor
module. When that module is full,
move to the leftmost 308EC or
206 module. Fill each module
before moving on to the next
module to the right.
b. Route each cord through the hook
on the front of the module.
c. Connect the free end of each
modular telephone cord to the
modular wall jacks for system
extensions.
d. Dress the wires. Gather the line
and extension cords hanging
below the hooks of the first two
modules and twist tie or wire wrap
them. Repeat for the remaining
cords. For the 5-Slot Carrier, place
each bundle of wires in the
indentations cut out of the bottom
edge of the carrier.
6 If you have a 5-Slot Carrier
configuration, install the cover as
follows:
a. Make sure all modules are seated
properly. The cover will not fit if the
modules are not seated properly.
b. To cover the modules, grasp the
upper edges of the cover and hold
it squarely over the control unit. It
is important to install the cover to
keep the modules dust-free and
the system working efficiently.
c. Place the cover over the modules
and make sure it fits firmly in
place.
d. Insert the #6 screw into the tab on
the lower front of the cover.
Tighten the screw.
To Next Page
Loading...
